quick disconnect

Status
Not open for further replies.
1

101010

Senior Member
I have a client that has about 30 qmark infared heaters that are mounted to a concrete cieling. They are looking to have a quick disconnect so they can take the heaters down and put them back up. They dont want to undue the wirenuts . Need some type of harness that pulls apart. They are 220v 15 amps each. There is already a switch next to each unit to kill the power.
 
Iam just looking for something I can use inside feed trough. They are made in a way that the heater cabinet and elements come apart from the feed trough. Iam loking for a part like a cieling fan light has
 
try what stickyboy said; i think what you are specifically looking for is a pin & sleeve, which i guess you could say is what a ceiling fan light kit has. you just need a larger version. try any device manufacturer for this. http://www.leviton.com
 
Take a look at mcmaster.com, catalog page 724 at the bottom, in particular part numbers 7243K31 and 7243K32.

These _may_ be suitable for your application, however you would need to confirm proper strain relief, proper conductors, and proper crimping. You would probably have to get the datasheet for the parts.

-Jon
 
101010 said:
Iam just looking for something I can use inside feed trough. They are made in a way that the heater cabinet and elements come apart from the feed trough. Iam loking for a part like a cieling fan light has
Click to expand...


That part is called a MOLEX connector.....check out radio shack...
 
Last edited:
Status
Not open for further replies.
Top