Dsg319
Senior Member
- Location
- West Virginia
- Occupation
- Wv Master “lectrician”
I know mathematically this will be extremely low current and won’t even come close to tripping a equipment fault breaker.(30ma)
But anyways I had to do a bunch of in line splices on a heat trace run and I always check before powering up. But instead of getting the typical OL. (Open circuit)
I’m getting 300k-400k ohms between bus wires to equipment ground sheath on the cable.
Should I be concerned?
But anyways I had to do a bunch of in line splices on a heat trace run and I always check before powering up. But instead of getting the typical OL. (Open circuit)
I’m getting 300k-400k ohms between bus wires to equipment ground sheath on the cable.
Should I be concerned?
Last edited:
