Seal off question

[Mule]

It's been a while since I've done any art 500 work, and I've sub'd out for a service station job, changing out sump's below fuel dispensers. My job is to disconect wiring and re-connect after new sumps are set. My question is this, the dispensers were wired using EYS's,UNF's and cap L's...what is the type of "seal off" that has the larger "screw in" filling neck? I just remeber them being easier to stuff and easier to "chip out" during future demo's

 

[stickelec]

It's been a while since I've done any art 500 work, and I've sub'd out for a service station job, changing out sump's below fuel dispensers. My job is to disconect wiring and re-connect after new sumps are set. My question is this, the dispensers were wired using EYS's,UNF's and cap L's...what is the type of "seal off" that has the larger "screw in" filling neck? I just remeber them being easier to stuff and easier to "chip out" during future demo's

For Crouse-Hinds this should do it.

http://www.crouse-hinds.com/catalog/PDFS/00184to00185.pdf

 

[Jhaney]

for appelton try this

http://www.appletonelec.com/pdf/I 2-3 6thru16.pdf

for oz-gedney try this

http://www.o-zgedney.com/PDF/BA 6thru13.pdf

 

[Mule]

YES YES Thanks the crouse-hinds EZS was it........thanks to both of you..