shared neutral circuits (MWBC) into Protected Load Panel

[Zee]

My understanding is that if I move one half of a multi-wire branch circuit (MWBC) from an existing sub panel to a new Proteced Loads Panel (battery backup) I am required to move the other half too.
Basically, if black wire goes, so does red?
Is this correct?

This is gonna suck because I will fill up the precious space in home owner's new Protected Loads Panel (only 25A max supply from inverter) with unwanted circuits.

 

[infinity]

A MWBC requires simulatneous disconnection of both circuits so they both need to originate in the same panel.

 

[texie]

A MWBC requires simulatneous disconnection of both circuits so they both need to originate in the same panel.

In addition, the neutral must connect in the same panel as the circuit(s).

 

[jaggedben]

In addition, if loads are turned on on the legs you didn't move, the system may try to push power to them in off grid mode, which is pretty bad for mutliple reasons.

 

[jaggedben]

And yes it sucks and sometimes you have to make compromises.