site test code

[Leo Li]

Hi Friends, is there any NFPA code or other code to follow for electrcial equipment site hand-over test suh as transformer, MCC controller, generator etc,.? Now I only can find NECA90 Commissioning BUilding Electrical system. Thanks!

 

[dkidd]

NETA

https://www.netaworld.org/standards/ansi-neta-ats

 

[tom baker]

Look in the COPS article, it’s 700 something, maybe 708. It has a section on commissioning

 

[Leo Li]

NETA

https://www.netaworld.org/standards/ansi-neta-ats

thanks!

 

[Leo Li]

Look in the COPS article, it’s 700 something, maybe 708. It has a section on commissioning

Thanks!

 

[Leo Li]

NETA

https://www.netaworld.org/standards/ansi-neta-ats

Hi Sir， is this code mandatory or just optional for new building factory? From my point of view and some test should be factry test but not site acceptance test such as "Determine long-time pickup and delay by primary current injection" test for MCCB to verify MCCB quality.

Thanks again!

 

[tom baker]

Hi Sir， is this code mandatory or just optional for new building factory? From my point of view and some test should be factry test but not site acceptance test such as "Determine long-time pickup and delay by primary current injection" test for MCCB to verify MCCB quality.

Thanks again!

Optional, you would include in your project specs.
Notice the title is “recommended”

 

[Leo Li]

Optional, you would include in your project specs.
Notice the title is “recommended”

That is great, appriciated for this reply!

 

[petersonra]

Commissioning and testing is a separate item from installing. Sometimes it is done by the same people, sometimes not. It is often a radically different skill set.

 

[Leo Li]

Commissioning and testing is a separate item from installing. Sometimes it is done by the same people, sometimes not. It is often a radically different skill set.

well known! Thanks !