Spot the Violations.......
- Thread starter 480sparky
- Start date
- Status
Violation??
Where to start.
1. The bell should be installed clapper up instead of clapper down.
2. The wires should have two full wraps around the board for proper supportage.
3. The wire nuts should be taped individually, not in tandem.
4. Funky looking wires out the top of the panel on the right.
Otherwise - pretty darn impressive (expeshly the short radius conduit bend.)
db
Where to start.
1. The bell should be installed clapper up instead of clapper down.
2. The wires should have two full wraps around the board for proper supportage.
3. The wire nuts should be taped individually, not in tandem.
4. Funky looking wires out the top of the panel on the right.
Otherwise - pretty darn impressive (expeshly the short radius conduit bend.)
db
LarryFine
Master Electrician Electric Contractor Richmond VA
- Location
- Henrico County, VA
- Occupation
- Electrical Contractor
Really! :roll:
Jim W in Tampa
Senior Member
- Location
- Tampa Florida
send pictures to electrical department of building department with address on back
e57
Senior Member
- Location
- San Francisco, CA
I like it - a panel with an arm rest.
Sierrasparky
Senior Member
- Location
- USA
- Occupation
- Electrician ,contractor
Hey there aint nothin wrrrong with that work. That took mee hourrrs to dooooooo. :grin:
Nope.... SFD.
- Status