• We will be performing upgrades on the forums and server over the weekend. The forums may be unavailable multiple times for up to an hour each. Thank you for your patience and understanding as we work to make the forums even better.

Stamptec press.

Learn the NEC with Mike Holt now!
Status
Not open for further replies.
masterinbama

masterinbama

Senior Member
Location
Huntsville Alabama
Anyone here know anything about stamptec presses?

We removed bad conduits and replaced all with grs. Reconnected all the wiring as it was removed. Machine will run in manual but not in automatic. Any ideas?

Sent from my LML211BL using Tapatalk
 
R

ramsy

Roger Ruhle dba NoFixNoPay
Location
LA basin, CA
Occupation
Service Electrician 2020 NEC
If raceway repair closed EGC path where it was previously broken, try temporarily breaking it again.
 
Last edited:
iceworm

iceworm

Curmudgeon still using printed IEEE Color Books
Location
North of the 65 parallel
Occupation
EE (Field - as little design as possible)
That will work. Electrons follow the same physics. Chinese, Japanese, Russian, German. Yugoslavian- all good. Elbownian, Albanian - those are tough
 
masterinbama

masterinbama

Senior Member
Location
Huntsville Alabama
Am going to do what nobody here does, post the solution.

Found that when we removed 1 wire from terminal 21 and relanded it, a jumper had fallen out from an adjacent terminal. Problem solved.

Sent from my LML211BL using Tapatalk
 
ptonsparky

ptonsparky

Tom
Location
NE (9.06 miles @5.9 Degrees from Winged Horses)
Occupation
EC - retired
Back when you could actually see the components, I took a night class in electronics and managed to find a broken resistor for a customer. A trip to Radio Shack solved the problem. Not long after that, components disappeared. Missing jumpers are about all I can look for now. If I can find my glasses and there is enough light.
 
Status
Not open for further replies.
Top