Sub Panel Grounding

[AES1005]

Any Idea's on how to run a EGC for a subpanel to feed back to the main when the original installation only a three conductor cable was installed. All of the walls are up and painted. I realize the conductors are to be in the same raceway, just looking to see if anyone has run into this before.

 

[M. D.]

Are there any 220 volt circuits???? If not remark , remake and make it happen:smile:

 

[AES1005]

may work

may work

Yes, there is a whirlpool, but I see what you mean I could re-route the power to the whirlpool and everything else would be 110v

 

[electricalperson]

Any Idea's on how to run a EGC for a subpanel to feed back to the main when the original installation only a three conductor cable was installed. All of the walls are up and painted. I realize the conductors are to be in the same raceway, just looking to see if anyone has run into this before.

i would get a hammer and sawzall and start making holes to run a new cable.

 

[AES1005]

Thank's for the help, Your'e right the way to fix it is to run a new 4 conductor cable. Call the drywaller's.

 

[E.C.]

Is the cable in emt perhaps?

 

[AES1005]

No EMT, It's just a regular SE cable #2 100 amp panel.