surface metal raceway

Status
Not open for further replies.
possible answer: wiremold:

Answer:
The 600B Bender is used to make bends, saddles and offsets in the 500 and 700 series raceways.
 
Yeah. I just made a couple 3/4" offsets using my 3/4" EMT bender last week. Sometimes you need to tweak it back into shape with the channels after bending.

Mark
 
Like everyone else said we just use a 3/4 bender, you will want some some matching paint because it sometimes chips when you bend it. We always get a can of paint when we run wiremold anyways for touch up.
 
Yeah. I just made a couple 3/4" offsets using my 3/4" EMT bender last week. Sometimes you need to tweak it back into shape with the channels after bending.

Mark


Ditto...If you try to use the 1/2" bender, it will get the job done, but not as neat of a job with using the 3/4" bender. Even then, have the channel locks ready...(And maybe some touch-up paint?:roll:)
 
Status
Not open for further replies.
Top