Tanning Beds

[gswaits]

Hi,
I will be installing Three tanning beds pulling 70A, 40A and 30A. The beds will be located in seperate rooms and the panel is in the back storage room.

I am wondering if there is anything in the code that specifically covers these types of installations.

If the unit is hard wired don't I need a disconnect at each bed or would the switch and or timer cover this?

It is a three phase panel 120/208.

Thanks for any suggetions or comments.

Greg

 

[tom baker]

Re: Tanning Beds

Start with the mfgs instructions. What are they listed as?
Knowing that find the appropiate code article.

[ May 24, 2005, 03:05 PM: Message edited by: tom baker ]