Alwayslearningelec
Senior Member
- Location
- NJ
- Occupation
- Estimator
When you have an existing circuit and you want to check total load currently on it what is that called?
Test Called?
- Thread starter Alwayslearningelec
- Start date
LarryFine
Master Electrician Electric Contractor Richmond VA
- Location
- Henrico County, VA
- Occupation
- Electrical Contractor
It's called "checking the total load currently on an existing circuit."
The simplest way is to use a clamp-on ammeter.
ATSman
ATSman
- Location
- San Francisco Bay Area
- Occupation
- Electrical Engineer/ Electrical Testing & Controls
Load Current Measurement Test ?
This refers to a one time current measurement using a clamp on instrument. Now if you are talking about loads over time then that is usually referred to as Load Monitoring and Recording. This is usually done before a breaker is added to a distribution panel.
This refers to a one time current measurement using a clamp on instrument. Now if you are talking about loads over time then that is usually referred to as Load Monitoring and Recording. This is usually done before a breaker is added to a distribution panel.
LarryFine
Master Electrician Electric Contractor Richmond VA
- Location
- Henrico County, VA
- Occupation
- Electrical Contractor
Wanna bet?