threaded rod
- Thread starter wyatt
- Start date
- Status
- Location
- Lockport, IL
- Occupation
- Semi-Retired Electrical Engineer
Re: threaded rod
From the manufacturer?
From the manufacturer?
- Location
- Bremerton, Washington
- Occupation
- Master Electrician
Re: threaded rod
Your design stregth would typically be twice the working weight. I have seen specs for siesmic restraint that required the conduit weight to be determined by it being considered full of water.
Probably the weakest link will be the anchor if its a concrete ceiling....
Your design stregth would typically be twice the working weight. I have seen specs for siesmic restraint that required the conduit weight to be determined by it being considered full of water.
Probably the weakest link will be the anchor if its a concrete ceiling....
rcwilson
Senior Member
- Location
- Redmond, WA
Re: threaded rod
The B-Line catalog used to have some good information on rod strength, suports, safety factors etc.. Try an on-line search.
The B-Line catalog used to have some good information on rod strength, suports, safety factors etc.. Try an on-line search.
TOMWELDS
Member
- Location
- Westchester Cty. New York
Re: threaded rod
The 'American Electricians Encyclopedia' is usually good for questions like this.
The 'American Electricians Encyclopedia' is usually good for questions like this.
- Status