Just looking for confirmation and code reference for requirement of the use of torque screwdrivers in panelboards and for other equipment terminations.
Is there a code requirement other than 110.14 FPN?
This is probably not the right forum for this question... I will post it in the NEC forum.
[ July 23, 2003, 09:29 AM: Message edited by: slicer ]
Is there a code requirement other than 110.14 FPN?
This is probably not the right forum for this question... I will post it in the NEC forum.
[ July 23, 2003, 09:29 AM: Message edited by: slicer ]
