N NMCB13 Member Location Florida May 16, 2007 #1 When terminating copper or aluminum feeders, where can I find the torque requirments?
D davidr43229 Senior Member Location Columbus, Oh May 16, 2007 #2 If it within an Industrial Control panel consult UL508A. If it is in a standard Electrical Distribution System, consult the manufacturer if there is not a label on the side of the device which you are terminating the wire. Just my $.02
If it within an Industrial Control panel consult UL508A. If it is in a standard Electrical Distribution System, consult the manufacturer if there is not a label on the side of the device which you are terminating the wire. Just my $.02
B bphgravity Senior Member Location Florida May 16, 2007 #3 The torque values will be labeled on the termination device itself or on other product markings/instructions.
The torque values will be labeled on the termination device itself or on other product markings/instructions.
