Vertical support of schedule 40 pvc

[LooseNeutral]

Can only find it for horizontal. Thought that I had seen it before , but for the life of me I cannot find it.

 

[480sparky]

I didn't know there was a difference. Where did you find it for horizontal runs?

 

[donselectric]

clips are cheap 2 per stick is my norm
1-1/4 and up 3

 

[celtic]

sparky....352.20(B)

LooseNuetral....the above section states:

Conduit listed for support at spacings other than as shown in Table 352.30(B) shall be permitted to be installed in accordance with the listing.

Barring some info from the manufac., NEC rules apply.

 

[LooseNeutral]

I found it at Table 352.30(b). Took it as meaning horizontal only. Maybe it means both. I thought vertical support could be less. Maybe I am wrong.

 

[480sparky]

It speaks of horizontal runs through framing members.

 

[celtic]

It speaks of horizontal runs through framing members.

...and a bit more...

Horizontal runs of RNC supported by openings through framing members at intervals not exceeding those in Table 352.30(B) and securely fastened within 900 mm (3 ft) of termination points shall be permitted.

 

[LooseNeutral]

I looked at RMC 344.30(b) (3) and saw vertical support there. Thought it might hold some weight here. But thanks for the help.