I am phasing out my LCP-1 Wattstopper Controllers. I had some bad boards in one of them so I replaced them with some boards in my Parking Lot Lights controller. For some reason, I cannot make the boards come on either by using an external switch or with a group signal. Anyone ever heard of this?
I wiped out the card and restored it to factory default (so it says on the programmer) but it retains the "On Inhibit" function no matter what I do. Even changing it in the programmer to a different type does not work even though the programmer says it changed. This is an LCB-308 Board that I am taking about.
Thanks in advance
I wiped out the card and restored it to factory default (so it says on the programmer) but it retains the "On Inhibit" function no matter what I do. Even changing it in the programmer to a different type does not work even though the programmer says it changed. This is an LCB-308 Board that I am taking about.
Thanks in advance
