Wet Bar Locations and Wiring

[Megatwon]

Is underneath a bar counter where the wet glasses will be drying considered a wet location? Is it ok to run mc under there to a 4 sq with two gfcis or does it need to be ran in sealtite or carlon to a bell box? Thx

 

[ActionDave]

Welcome to the forum.

MC and 4 sq is fine. Seal tite would be way over the top.

 

[infinity]

It would not be a wet location by the Article 100 definition.

Welcome to the Forum.

 

[Megatwon]

Welcome to the forum.

MC and 4 sq is fine. Seal tite would be way over the top.

Lol thx. Btw when wiring two gfcis in same box would you wire them in line or go line to line between the two then load side for downstream receptacles?

 

[hbiss]

I would just use one GFCI in the first box to feed the whole thing including a regular receptacle next to it in that box. Why would you want two in the same box?

-Hal

 

[Megatwon]

I would just use one GFCI in the first box to feed the whole thing including a regular receptacle next to it in that box. Why would you want two in the same box?

-Hal

Ive just seen it that way. Maybe its an esthetic thing.