What were they on? Reddit post.
- Thread starter norcal
- Start date
- Status
ptonsparky
Tom
- Occupation
- EC - retired
What do you want?!! It's strapped!
readydave8
re member
- Location
- Clarkesville, Georgia
- Occupation
- electrician
Put in at different times, older runs were dodging obstacle that was since removed?
ptonsparky
Tom
- Occupation
- EC - retired
It's above a 'fault line?'
hbiss
EC, Westchester, New York NEC: 2014
- Location
- Hawthorne, New York NEC: 2014
- Occupation
- EC
Looks like they wanted to use up the scrap pile.
-Hal
-Hal
LarryFine
Master Electrician Electric Contractor Richmond VA
- Location
- Henrico County, VA
- Occupation
- Electrical Contractor
synchro
Senior Member
- Location
- Chicago, IL
- Occupation
- EE
Maybe they wanted to use up the 360° of bends that are allowed. 
As mentioned in the reddit post, it appears that there are screws going into the conduit itself. For example, one at the bottom of the picture is shown below. It looks like they may have used a 2-hole strap and bent it to do this.
As mentioned in the reddit post, it appears that there are screws going into the conduit itself. For example, one at the bottom of the picture is shown below. It looks like they may have used a 2-hole strap and bent it to do this.
texie
Senior Member
- Location
- Fort Collins, Colorado
- Occupation
- Electrician, Contractor, Inspector
Yep, must be the same crew.
brantmacga
Señor Member
- Location
- Georgia
- Occupation
- Former Child
That’s methed up.
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
LarryFine
Master Electrician Electric Contractor Richmond VA
- Location
- Henrico County, VA
- Occupation
- Electrical Contractor
It thertainly is!
LarryFine
Master Electrician Electric Contractor Richmond VA
- Location
- Henrico County, VA
- Occupation
- Electrical Contractor
"No, guys! 360 degrees is the maximum, not the minimum!"
- Status