I had a quick question, that i was hoping someone out there would know! i recently got a violation on a job, where i had used wiremold in a sunroom extension on a house. My violation was because i did not use the correct amount of strapping divices to support the wiremold...My question is, what is the offical code # and quote, about strapping requirments on horizontal wiremold raceways???? Thank you SOO much guys
WIREMOLD CODE ILLINOIS
- Thread starter lingwai1
- Start date
- Status
- Location
- Massachusetts
Re: WIREMOLD CODE ILLINOIS
From the NEC he might just hit you with 300.11 (A) Raceways, cable assemblies, boxes, cabinets, and fittings shall be securely fastened in place.
Did you support it according to the manufactures instructions?
[ July 08, 2003, 09:30 PM: Message edited by: iwire ]
From the NEC he might just hit you with 300.11 (A) Raceways, cable assemblies, boxes, cabinets, and fittings shall be securely fastened in place.
Did you support it according to the manufactures instructions?
[ July 08, 2003, 09:30 PM: Message edited by: iwire ]
russ
Senior Member
- Location
- Burbank IL
Re: WIREMOLD CODE ILLINOIS
I agree Bob, There doesn't seem to be anything more definite than that.
lingwail, are there any installation instructions you could say you followed.
Russ
[ July 08, 2003, 09:36 PM: Message edited by: russ ]
I agree Bob, There doesn't seem to be anything more definite than that.
lingwail, are there any installation instructions you could say you followed.
Russ
[ July 08, 2003, 09:36 PM: Message edited by: russ ]
- Status