Wiremold questions

[Happ1]

Im going to be using 6000 wiremold in a setting where i need to “jump” the low voltage cables over the power to get out of the bottom in specific locations.

the data will run the top and the power will run the bottom of mold, there will be a divider in between.

in certain spots the data will need to drop out of the bottom of the mold.

my question is , how should i, or better yet how would you protect the cables during the transition

 

[cadpoint]

I'm probably doing it wrong ...
Where you cut your slope or drill your hole, you can drill another one or two beside either to tie wrap one or both to suit
drop or orientation.