wiring herman miller partitions

[geochurchi]

Hi, I am looking for a creative way to wire these cubes, no power poles please,all of our feeds come from the floor below we presently use tombstones for power and data,data is run through the chanell below the panels and the power is fed by seal tight to 4" sq's. screwed underneath the work surfaces. What a nightmare to install.

 

[infinity]

We usually core drill a 3 or 4" hole and use a poke through into the ceiling below. A conduit is run out of the bottom of the panel into the same ceiling and the two are connected together. Then a whip is installed into the box at the partition.