- Location
- Chapel Hill, NC
- Occupation
- Retired Electrical Contractor
I am sure some of you have used stainless steel emt and I have a very small job where I may have to make one 90? bend. I was wondering if that can be done easily with a standard bender or do I have to buy prefab 90's.
This is for lighting on a trellis. Architect wants SS so instead of $100 worth of pipe it will be about $2200. Now he wants SS boxes even though they won't be seen. Do they make SS octagons? I have found 4" sq. SS but have not seen 4" octagon
This is for lighting on a trellis. Architect wants SS so instead of $100 worth of pipe it will be about $2200. Now he wants SS boxes even though they won't be seen. Do they make SS octagons? I have found 4" sq. SS but have not seen 4" octagon