lewis3180jdl
Member
I am currently starting a project that consists of tilt up panel construction. I have never done a job like this and was hoping for some help. I need to rough in the walls for devices both inside and outside of the building. How do you guys do this. Do you run pvc in the walls and just support everything frlm the rebar?
If so what do you use to support boxes etc. Also if i am instaling boxes for receptacles on the inside of the building how do you support those boxes and assure that they will be flush with the inside of the wall. Do you just stub pvc up or down the wall?
I knlw this is a long post but I am just looking for some pointers. Any help would be appreciated. Pictures would also help.
Thanks a lot
If so what do you use to support boxes etc. Also if i am instaling boxes for receptacles on the inside of the building how do you support those boxes and assure that they will be flush with the inside of the wall. Do you just stub pvc up or down the wall?
I knlw this is a long post but I am just looking for some pointers. Any help would be appreciated. Pictures would also help.
Thanks a lot