A/A Fuel GTX
Senior Member
- Location
- WI & AZ
- Occupation
- Electrician
I was thinking today about some of the "out of the ordinary" practices I've seen over the years. One that stands out is that I worked with a guy that when wiring a MWBC, would lay out the full length of the run on the floor. Then he would take the 3 or 4 (# 12's) and put the end of them in a drill motor, have another guy holding the wires on the other end and subsequently turn on the drill and end up with a twisted bundle of wire. He would then pull the wires into the conduit. I always thought that would violate 110.3 (5) at the very least but he never gave it a second thought. I'm sure there are a plethora of other stories out there.........
Last edited: