chris kennedy
Senior Member
- Location
- Miami Fla.
- Occupation
- 60 yr old tool twisting electrician
Sent to wire up a spray booth and this is where I need to pull two 3? 20A circuits from. Any existing violations here I may need to correct?
So did they burn up the buss on the lefthand panel and just swap everything over to a new panel on the right instead of just replacing it?
Green wires as ungrounded conductors, and neutrals not originating in the same panel and other nipple-heating problems?Yes sir, but I see 2 glaring violations here and nobody has cited them yet, you guys are slackin.:roll::grin:
Green wires as ungrounded conductors, and neutrals not originating in the same panel and other nipple-heating problems?
Can't remember it off hand - but generally says 'Shall originate in the same panel board'.... Well they kinda do - but don't....Code section?
IMO - a simple sizable say #4-2 noodle in each nipple will kill the heating issue if any at all... but still not right. :roll:
Yes sir, but I see 2 glaring violations here and nobody has cited them yet, you guys are slackin.:roll::grin:
Is it still a panel? There is no OCP in it.... IMO the one on the right was a 1/2 donkeyed attempt at correcting that.Well, photos can sometimes be a tad misleading, but there seems to be a SHELF built right across the left panel.