MichaelZlab
Member
- Location
- Hebron, Ne., USA
Hello,
My question is:
Is there a tap rule that works like this? This is in regards to 240.21 If I have a 3 phase welder that is fed from a 40 amp disconnect, all 3 legs are fused to 40 Amps. Is it permissible to take 12 ga. taps from the load side of that disconnect and feed another device. The line is less than 10 feet and is fused at the device to 10 amps.
Thank you!
My question is:
Is there a tap rule that works like this? This is in regards to 240.21 If I have a 3 phase welder that is fed from a 40 amp disconnect, all 3 legs are fused to 40 Amps. Is it permissible to take 12 ga. taps from the load side of that disconnect and feed another device. The line is less than 10 feet and is fused at the device to 10 amps.
Thank you!