once again I'm rewiring a house that has a decent amount of k&t. It's a basic layout with kitchen/dining/living plus bath on the main level and bedrooms and bath on second level.
Some of it has been changed out, but the upstairs (attic, bedrooms and bathroom), and the ceiling portion of the main level are predominately k&t.
The attic has blown in insulation (thankfully not vermiculite) so it's challenging to see the runs of k&t.
Does anyone one have any diagrams as to how a house is typically wired using k&t? I want to abandon all that I can, but I don't want to start chopping wire without knowing how it's run.
i already fished wire up into the attic from the basement. That will replace the k&t for lites and receps in the upstairs area (I'll fish down from the attic).
Its that transition between the main floor ceiling and the upper floor that I have limited access to.
Wishing I had more knowledge about how the wires are run in this transition area....
Some of it has been changed out, but the upstairs (attic, bedrooms and bathroom), and the ceiling portion of the main level are predominately k&t.
The attic has blown in insulation (thankfully not vermiculite) so it's challenging to see the runs of k&t.
Does anyone one have any diagrams as to how a house is typically wired using k&t? I want to abandon all that I can, but I don't want to start chopping wire without knowing how it's run.
i already fished wire up into the attic from the basement. That will replace the k&t for lites and receps in the upstairs area (I'll fish down from the attic).
Its that transition between the main floor ceiling and the upper floor that I have limited access to.
Wishing I had more knowledge about how the wires are run in this transition area....