VaconX4DriveAccelerateToSpeedFor25MinutesThenStop

Learn the NEC with Mike Holt now!
Status
Not open for further replies.
G

gbradley

Member
Location
Anaheim
Occupation
Engineer
I have a VACON X4 drive

I want a digital input to Accelerate the motor up to Speed (43Hz) then stay at speed for 25 minutes, and then Decelerate back to 0 speed.

On the Woods WFC drive I used C1- Cntl1 01000111and E1-Ecnt1 of 1500sec

Do I change Param 405?
 
petersonra said:
your best bet might be to call danfoss tech support
Click to expand...
I did call tech support.
I found out that not only are the Woods Drive WFC obsolete, but that the Vacon X4 are in the Inactive phase and at End of life as well.
Anyway he suggested 491 Seq Appl
I will have to read up a little, but I believe that this will get me to where I want to go.
Thanks
 
Status
Not open for further replies.
Top