Is this a fail ? Or is this acceptable

[Libertywalk]

Keep in mind it’s a short run. So in my head I was just thinking it didn’t need to be strapped but I was trying to be creative and in my head it looked nice having the symmetrical bends . But I always enjoy learning more about the code and would appreciate the input if it’s considered a code violation

 

[Cursitti]

Check out 300.11(B)

 

[ptonsparky]

Check out 300.11(B)

...Wiring Systems Installed Above Suspended Ceilings

hmmm

 

[Cursitti]

...Wiring Systems Installed Above Suspended Ceilings

hmmm

lol sorry I just woke up on vacation brain is not functioning properly yet. My mistake

 

[ptonsparky]

Short or not I would say it needs to be fastened per 358.30(A)

Only your AHJ will know if your inventive method is acceptable.

 

[infinity]

So in my head I was just thinking it didn’t need to be strapped but I was trying to be creative and in my head it looked nice having the symmetrical bends

A support is required. I don't see a code violation because the straps are bolted together so one raceway is not supporting the other.

 

[winnie]

The only problem that I see is that the outer strap isn't fastening the conduit against anything.

 

[infinity]

The only problem that I see is that the outer strap isn't fastening the conduit against anything.

Is that really required? Ever hang a run of tubing from the deck above with threaded rods?

I changed my mind see post 13.

 

[electrofelon]

I do see one violation from Ethan's quality manual: take off those gaskets on the rain tight fittings and throw them as far as you can!

 

[jim dungar]

The only problem that I see is that the outer strap isn't fastening the conduit against anything.

If the conduit from the wall was not there the outside conduit would be supported by using a standoff. Therefore the inside conduit is not directly supporting the outside, just like infinity said.

 

[Dsg319]

Just for looks if I had to have the conduits flat like you have I would have opted for a L bracket and horizontal strut with a cap on the end.

 

[electrofelon]

At first I thought it was a "back to back cowboy". (Sounds dirty) But I took a closer look and it appears that the outer support is one hole strap. I would not find that acceptable.

 

[infinity]

At first I thought it was a "back to back cowboy". (Sounds dirty) But I took a closer look and it appears that the outer support is one hole strap. I would not find that acceptable.

You're right. I missed the one hole strap part which is what Winnie was referencing. Therefore I'm changing my initial response to say this is not properly supported.

 

[ActionDave]

Swap that one hole out with a mini and it's good.

 

[infinity]

Swap that one hole out with a mini and it's good.

I agree initially I didn't look close enough at the photo.

 

[hbiss]

Just for looks if I had to have the conduits flat like you have I would have opted for a L bracket and horizontal strut with a cap on the end.

Was thinking the same thing. Or make an L bracket up and use two cowboys. Might have to make the bracket wide enough so you could stagger the cowboys because you might not be able to have them in line without hitting each other.

-Hal

 

[jim dungar]

Was thinking the same thing. Or make an L bracket up and use two cowboys. Might have to make the bracket wide enough so you could stagger the cowboys because you might not be able to have them in line without hitting each other.

-Hal

Why so much effort.

Even simply adding a second one hole strap, on the bottom, would meet the requirements of support and securing.

 

[hbiss]

Even simply adding a second one hole strap, on the bottom, would meet the requirements of support and securing.

Ya know, that's a good idea! But they would probably hit each other.

-Hal

 

[ptonsparky]

Why so much effort.

Even simply adding a second one hole strap, on the bottom, would meet the requirements of support and securing.

Turn over and you have support.

 

[hbiss]

Turn over and you have support.

Yeah, but not laterally. I think Jim's idea is the best yet with two one hole straps even if you have to grind the ends off a little.

-Hal