Good afternoon all i need some assistance/ guidance here , i have a project in a pretty remote part of south jersey where we need about 1200 amps
long story short pseg is telling me the only thing they can provide me with is 13.2 and i would need to step it down from there , the problem is i have never worked with anything this large
1 . does this transformer need to be in a room or pad mount is ok
2. im assuming pseg will hook up the primary side ?
3. would pseg or an poco for that matter require certain certifications for high voltage?
4. what is required by the nec on the secondary side? just a single service disconnect feeding the new 480 1200 amp service?
5 where would one even go to purchase a transformer like this or should poco be suppling this?
any feedback would be greatly apricated
long story short pseg is telling me the only thing they can provide me with is 13.2 and i would need to step it down from there , the problem is i have never worked with anything this large
1 . does this transformer need to be in a room or pad mount is ok
2. im assuming pseg will hook up the primary side ?
3. would pseg or an poco for that matter require certain certifications for high voltage?
4. what is required by the nec on the secondary side? just a single service disconnect feeding the new 480 1200 amp service?
5 where would one even go to purchase a transformer like this or should poco be suppling this?
any feedback would be greatly apricated