jeff aloisi
New member
- Location
- great barrington massachusetts
HOW CLOSE CAN I INSTALL A 400 AMP 120/208 VOLT PANEL FROM A SINK. INSPECTOR STATES 17" BUT WAS NOT CERTAIN. THIS IS A 6' LONG SS SINK.
400 AMP MDP IN COMMERICAL KITCHEN.
- Thread starter jeff aloisi
- Start date
- Status
- Location
- Chapel Hill, NC
- Occupation
- Retired Electrical Contractor
There is no code on distance from a sink as long as the clearances are made. Now if you have a local amendment but I am betting that 17" is made up.
jumper
Senior Member
- Location
- 3 Hr 2 Min from Winged Horses
Is this a service?
230.70(A)
(2) Bathrooms. Service disconnecting means shall not be
installed in bathrooms
230.70(A)
(2) Bathrooms. Service disconnecting means shall not be
installed in bathrooms
- Location
- New Jersey
- Occupation
- Journeyman Electrician (retired)
jumper
Senior Member
- Location
- 3 Hr 2 Min from Winged Horses
He did say kitchen.
yeah, some other fella noticed that also, it happens................
Cow
Senior Member
- Location
- Eastern Oregon
- Occupation
- Electrician
400 amp MDP 17" from a 6' sink? Yikes! That's probably bigger than some bathtubs!!
P.S. DO NOT SPLASH IN THE TUB!!
P.S. DO NOT SPLASH IN THE TUB!!
408.37 damp/wet locations refers to 312.2 which says enclosures need to be suitable for. IMO the AHJ needs to make the call on suitable for. If not, IMO I would refer to 110.26(A)(2) which says clearence is width of equipment or 30 inches, whichever is greater.
- Status