480V 3phase backup gen with 480v 3phase and 240/120 loads

[sovaff]

I have a 150kw 3phase 480V generator that I have been using to power a irrigation pivot and pump which is around 90KVa total. I would like the unit to be used as a backup generator for the facility that is also on site but is supplied by a 600A 240/120v service. Could I make this work, assuming I was to purchase 3x 480V - 240V /120V center tapped transformers and split the 600A panel into 3x 200A sub panels each fed by one phase? I cant see why I couldn't, but I am a farmer w an mech engineering degree and not an electrician. (I understand I would have to build an interlocking transfer switch using large contactors with, under and over voltage detection and time delays, I also understand I need to balance the load between phases as best possible)

 

[ActionDave]

I am closing this thread, in accordance with the forum rules. This Forum is intended to assist professional electricians, inspectors, engineers, and other members of the electrical industry in the performance of their job-related tasks. However, if you are not an electrician or an electrical contractor, then we are not permitted to help you perform your own electrical installation work.