Advice: Customer wants a 400a ATS and Gen to power entire house

Status
Not open for further replies.
mopowr steve

mopowr steve

Senior Member
Location
NW Ohio
Occupation
Electrical contractor
mopowr steve said:
Looks right, even though the listing shown says lug size for 600-#4 or 1/0-250 this must be a typo should say (2) 1/0-250. I’m sure that I checked this during the install if not printed on the lug then it must have been in the spec sheet.
Click to expand...
Actually the line side lugs had two Allen head holes for the two different sizes as listed but the load terminals did have a interesting shaped oblong hole for two conductors
 
G

gooblanzee

Member
Location
Charlotte
Occupation
Electrical Contractor
mopowr steve said:
Looks right, even though the listing shown says lug size for 600-#4 or 1/0-250 this must be a typo should say (2) 1/0-250. I’m sure that I checked this during the install if not printed on the lug then it must have been in the spec sheet.
Click to expand...
Cool. That typo was throwing me off as well. I assumed the same. Guess ill call generac tomorrow to be sure
 
Status
Not open for further replies.
Top