ibew441dc
Senior Member
The following is from the 08 UL White Book
Wire bending space in accordance with Article 373??? Does anyone know what the correct section is .........my gut sends me to 312.....but the 373's got me all messed up .....its like the 4th floor of a building:-?.........oh wait there is 4th floor........now I'm all messed up:grin:
I have 1 Hundred dollhairs for the one who can find Article 373 in the 08 NEC.:grin:
And a thanks for the corrected text according to UL.
POWER AND GENERAL-PURPOSE
TRANSFORMERS, DRY TYPE (XQNX)
USE AND INSTALLATION
This category covers transformers of the air-cooled, dry, ventilated and
nonventilated types rated 600 V or less; 500 kVA or less single phase; and
1500 kVA or less three-phase. Step-up, step-down, insulated, and autotransformer
types, as well as air-cooled reactors, are also included.
The transformers and reactors are provided with leads, or with studs or
terminal pads to which Listed pressure wire connectors can be factory or
field installed to accommodate field wiring. The adequacy of the wirebending
space, in accordance with Article 373 of ANSI/NFPA 70, ‘‘National
Electrical Code’’ (NEC), has not been determined and should be investigated........
Wire bending space in accordance with Article 373??? Does anyone know what the correct section is .........my gut sends me to 312.....but the 373's got me all messed up .....its like the 4th floor of a building:-?.........oh wait there is 4th floor........now I'm all messed up:grin:
I have 1 Hundred dollhairs for the one who can find Article 373 in the 08 NEC.:grin:
And a thanks for the corrected text according to UL.
Last edited: