ATS Location
- Thread starter KMeni
- Start date
- Status
chris kennedy
Senior Member
- Location
- Miami Fla.
- Occupation
- 60 yr old tool twisting electrician
Is your ATS service rated? I have never seen a service rated ATS without a main.
See 230.70C.
See 230.70C.
jrannis
Senior Member
- Location
- Fort Lauderdale/ Miami
Interesting to read the label inside of most non fused MTS say service entrance rated
only to add if it non-fused, you have to be careful about the interrupt rating...most, if not all, are 10k
- Location
- Massachusetts
I agree.
Pierre C Belarge
Senior Member
- Location
- Westchester County, New York
You can always add a service disconnect ahead of the ATS, if have already installed it.
hurk27
Senior Member
- Location
- Portage, Indiana NEC: 2008
it would also require OCPD's also if my reading of the code is still up to par?
charlie
Senior Member
- Location
- Indianapolis
It is interesting to me that we seem to all talk of, "Install the disconnect here" when we really mean, "Install the service disconnecting means and service overcurrent protection here." I believe we sort of lost the additional phrase when most people started using circuit breakers and they both were included in the same piece of equipment. :smile:
hurk27
Senior Member
- Location
- Portage, Indiana NEC: 2008
Yep Charlie, I have a bad habit of making sure the intent of the poster because of the few people here that might not realize he was talking about combo equipment that serves both requirements.
charlie
Senior Member
- Location
- Indianapolis
I sure understand that and it is not a bad habit. :smile:
- Status