- Occupation
- Licensed Electrician
Or the "bender" is faulty.
Both my 1/2 and 3/4 benders are Benfield.
Both my 1/2 and 3/4 benders are Benfield.
Bending a 90 degree "backwards"?
- Thread starter frequency
- Start date
- Status
- Occupation
- Licensed Electrician
I looked closer at your diagram, and I think I was doing it wrong. I would rock the bender back on the pipe lightly to line up the star.
So indeed the bender was faulty, but it was because he was not properly schooled. I'll try again on Monday.
So indeed the bender was faulty, but it was because he was not properly schooled. I'll try again on Monday.
- Status