Bending Radius

Status
Not open for further replies.
tjmicsak

tjmicsak

Member
Location
NY
Where can I find the bending radius allowed for a single conductor from a SE cable? The radius given in that specific question is for the cable assy.type, but what about the specific single cable type? XHHN?
 
Are you talking about wire bending space at terminals? If so take a look at 312.6, specifically table 312.6(B)

Nevermind, I see what you are asking now. :oops:

I don't think there is a requirement for a bending radius for an individual conductor, other then 300.34 for conductors over 600 volts. I could be(and probably am) wrong.

Chris
 
Bending Radius

No that is for over 600V. (I went by the index and did not check what the section was titled).
 
Status
Not open for further replies.
Top