JDB3
Senior Member
- Location
- San Antonio, Texas
With all the changes & all, a question comes to mind!
Power company mounts a combination meter/breaker enclosure on their pedestal (that has a driven ground rod inside of it) [this enclosure has no provision for a fourth wire {ground}].
The customer is then responsible to run power (conduit underground w/cable) to the house. I have bonded to the re-bar in the slab, connected to a ground rod outside of the slab, ran this #6 bare copper into the inside panel, & then terminated it to a ground bar kit. Should the neutral bar be bonded to the panel (the ground bar is attached to the panel)?
Feel free to ask any questions, if my wording is not clear!
Power company mounts a combination meter/breaker enclosure on their pedestal (that has a driven ground rod inside of it) [this enclosure has no provision for a fourth wire {ground}].
The customer is then responsible to run power (conduit underground w/cable) to the house. I have bonded to the re-bar in the slab, connected to a ground rod outside of the slab, ran this #6 bare copper into the inside panel, & then terminated it to a ground bar kit. Should the neutral bar be bonded to the panel (the ground bar is attached to the panel)?
Feel free to ask any questions, if my wording is not clear!