Any issues if I wrap dc conductors around aluminum rail? How about EMT?
Details:
In array, I used to run the DC PV source circuit conductors in the aluminum U-channel rail (ProSolar rail).
Now, I use a new racking system. Now I have come to wrap the dc optimizer conductors around the aluminum rail to support the conductors and shorten them.
Any issues with that?
3-6 wraps between each optimizer.
Sometimes it goes around an EMT also that is attached to rail.
These are never pairs of conductors with opposite flow, but single conductors..... just in case that matters.
350-370 Vdc. 9A.
Inductance, magnetism, other?
Details:
In array, I used to run the DC PV source circuit conductors in the aluminum U-channel rail (ProSolar rail).
Now, I use a new racking system. Now I have come to wrap the dc optimizer conductors around the aluminum rail to support the conductors and shorten them.
Any issues with that?
3-6 wraps between each optimizer.
Sometimes it goes around an EMT also that is attached to rail.
These are never pairs of conductors with opposite flow, but single conductors..... just in case that matters.
350-370 Vdc. 9A.
Inductance, magnetism, other?
Last edited: