garrisonm1
Member
- Location
- Maryland
are you allowed to make a splice in a disconnect
disconnect
- Thread starter garrisonm1
- Start date
- Status
ryan_618
Senior Member
- Location
- Salt Lake City, Utah
Re: disconnect
Sure. Make sure you comply with 312.8, however.
Sure. Make sure you comply with 312.8, however.
- Location
- Illinois
- Occupation
- retired electrician
Re: disconnect
See 312.8.
Don
See 312.8.
Don
ryan_618
Senior Member
- Location
- Salt Lake City, Utah
Re: disconnect
Ah, It gives a person a good feeling when Don confirms that your answer was correct.
Ah, It gives a person a good feeling when Don confirms that your answer was correct.
electricman2
Senior Member
- Location
- North Carolina
- Occupation
- Retired Electrical Contractor
Re: disconnect
You two must have been typing at the same time
You two must have been typing at the same time
ryan_618
Senior Member
- Location
- Salt Lake City, Utah
Re: disconnect
Its always a bit scary when Don posts right after you because he is right about 99.5% of the time!!!
Its always a bit scary when Don posts right after you because he is right about 99.5% of the time!!!
- Status