electronic ballasts and tvi

Status
Not open for further replies.
B

buck33k

Senior Member
Location
Washington state and North Carolina
I replaced two old fluorescent fixtures with new electronic ballast type with t-8 tubes. The customer's tv now has quite a bit of interference when these lights are turned on. The antenna is a rabbit ear type on top of the set.
The old fixtures caused no interference.
Any suggestions would be appreciated.
Also, I was wondering if there was a filter which could be installed in line with the antenna which would filter out this noise?
Thanks
Buck
 
Re: electronic ballasts and tvi

If there's a filter available to solve this problem, Radio Shack would be the place to get it.
 
Re: electronic ballasts and tvi

Many thanks for the replies. Ham radio interference on television is corrected by hi pass filter (on tv) or low pass filter (on transmitter). Maybe this would correct the problem. I'll check with Radio Shack today.
 
Status
Not open for further replies.
Top