mkgrady
Senior Member
- Location
- Massachusetts
I'm looking to transition from rigid conduit to emt in numerous locations. Does anybody make such a fitting? I prefer threadless on the GRC side. I hope to do this without threading any conduit. Die cast fittings are not OK per spec.
The application is GRC below 8 feet and EMT above. So anywhere I am coming down a wall from above must be rigid. Secondly, I need to penetrate a roof. above the roof must be rigid but not below. I would run the rigid through a pitch pocket and switch to EMT below the roof?
The application is GRC below 8 feet and EMT above. So anywhere I am coming down a wall from above must be rigid. Secondly, I need to penetrate a roof. above the roof must be rigid but not below. I would run the rigid through a pitch pocket and switch to EMT below the roof?