Hi All,
I hope everyone is having a good day. I have 50 feet of flexible strip lighting I am installing under the front, top lip of a bar. I wanted to see if anyone had any opinions or ideas how to extend the wiring from the controller / driver to the strip lights. The controller plugs into an outlet on server side of the bar with a remote control for the lights. I need to extend the wire, through the bar knee wall so it can feed the new strip lights, on the customer side. I have attached a picture. The left 4 wires are want need to be extended. I will install the controller in a JB on the server side of the bar. Tech support told me the output is 100vdc. The manufacturer is ZLED Lighting. Personally, I have never heard of them. They are located in NJ. As always I appreciate the input. I am mostly concerned about getting the 100vdc through the wall without over thinking it.
Thanks,
Jim
I hope everyone is having a good day. I have 50 feet of flexible strip lighting I am installing under the front, top lip of a bar. I wanted to see if anyone had any opinions or ideas how to extend the wiring from the controller / driver to the strip lights. The controller plugs into an outlet on server side of the bar with a remote control for the lights. I need to extend the wire, through the bar knee wall so it can feed the new strip lights, on the customer side. I have attached a picture. The left 4 wires are want need to be extended. I will install the controller in a JB on the server side of the bar. Tech support told me the output is 100vdc. The manufacturer is ZLED Lighting. Personally, I have never heard of them. They are located in NJ. As always I appreciate the input. I am mostly concerned about getting the 100vdc through the wall without over thinking it.
Thanks,
Jim
