Alwayslearningelec
Senior Member
- Location
- NJ
- Occupation
- Estimator
How does one make this bonding jumper terminationat a conduit? MIGB?
Ground @ Conduit
- Thread starter Alwayslearningelec
- Start date
- Location
- New Jersey
- Occupation
- Journeyman Electrician
Bonding bushing.
- Location
- Chapel Hill, NC
- Occupation
- Retired Electrical Contractor
If it is emt use a emt connector with a bonding bushing as Infinity stated.
- Location
- New Jersey
- Occupation
- Journeyman Electrician
Yup that would work. They also sell bonding bushings that fit directly on the end of EMT so you can save the cost of separate EMT connectors.
LarryFine
Master Electrician Electric Contractor Richmond VA
- Location
- Henrico County, VA
- Occupation
- Electrical Contractor
Mayhaps a box where the conduit terminates.
Alwayslearningelec
Senior Member
- Location
- NJ
- Occupation
- Estimator
It's aluminum conduit.
- Location
- New Jersey
- Occupation
- Journeyman Electrician
Doesn't change anything. Will it be threaded on the end? Is so a threaded bonding bushing will work.
LarryFine
Master Electrician Electric Contractor Richmond VA
- Location
- Henrico County, VA
- Occupation
- Electrical Contractor
Empty or with wires in it? Just curious, what size conduit and wires?
- Location
- New Jersey
- Occupation
- Journeyman Electrician
I'm guessing 4". Could be empty sleeves installed by the EC and wire pulled by others.