I went to job where builder ran 3/4 IMC, for pool equipment. They pulled in 8awg, and someone went and put a 1g bell box on top of the pipe and seal tight whipped to pool pump timer. They hooked up 12 awg in seal tight to the 8 awg and left pool light disconnected. I want to put one of those 2 space 4 circuit Nema3 subpanel where the bell box is. I would then put in a quad breaker 20-20-20-20 so I could power the light too. My problem is that this conduit is coming up out of the grass infront of the pool equipment. I don't really want to dig up and move the conduit, I want to place this small disconnect/subpanel on top of the conduit but I am afraid the conduit is not sturdy enough to hold this disc in mid air. I know on commerical roofs we use a sheet metal stand, but in grass I need some advice on what I can use to support my box. I thought about hammering in some strut but I'm sure it would rust, any ideas? Thanks.