I am in the middle of a PVC run and the home owner wants to change the route of my conduit. The only problem is the change is going to have some non-standard bend to it. I was thinking i could connect a piece of LFMC to the PVC, make the bend and connect it back to the PVC after the bend. It is a short run and is not exposed nor is it going to exceed the number of bends between boxes. Can I do this?
Is This Within Code
- Thread starter cosmo
- Start date
- Status
- Location
- New Jersey
- Occupation
- Journeyman Electrician (retired)
Sounds OK to me.
marinesgt0411
Senior Member
- Location
- Naples,FL 34110-9285
350.10 (1) where conditions of installations...require flexibility
sounds like it to me
sounds like it to me
busman
Senior Member
- Location
- Northern Virginia
- Occupation
- Master Electrician / Electrical Engineer
Why not just heat the PVC and bend it to the non-standard bend?
Mark
Mark
hardworkingstiff
Senior Member
- Location
- Wilmington, NC
busman said:
I was wondering the same thing.
Jim W in Tampa
Senior Member
- Location
- Tampa Florida
Cheaper to get the heat gun out.But see no violation to do it this way.
- Status