MI Cable

[Alwayslearningelec]

Anyone familiar with running this? As you see I have a lot. I know you need to transition over to wire type conductors when landing at equipment to terminate. I thought only way to really do that is mount a box and splice as shown below in link for single conductor MI. The multi conductor MI shows terminating directly at equipment enclosure.

 

[infinity]

In order to terminate directly on equipment it would need terminals listed for the large solid conductors shown in the video.

 

[Alwayslearningelec]

In order to terminate directly on equipment it would need terminals listed for the large solid conductors shown in the video.

Not following. Both the single conductor and the multi conductor transition to wire and terminate. One uses a separate box and one terminates directly on equipment enclosure.

 

[infinity]

Not following. Both the single conductor and the multi conductor transition to wire and terminate. One uses a separate box and one terminates directly on equipment enclosure.

Read my post again.