Neutral Bar

Merry Christmas
AC\DC said:
I don’t know if anyone stated this yet but when I come across those, I take all the grounds off and I just automatically either put them in like a six port Wego or a big blue wire nut- tie them together get a jumper largest EGC to an another group of jumpers .so I only have one wire going back to the bar
Click to expand...
Yes, I did. Many posts back.

-Hal
 
Little Bill said:
I just installed a Homeline a few months ago and it was not painted.
Click to expand...
Sounds like someone must have put a ABB, Siemens or Eaton loadcenter in a SquareD box.

Per SquareD specs:
Homeline finish consists of gray baked enamel electrodeposited over cleaned, phosphatized steel.

I have been buying HOM loadcenters since they were first launched. Of the thousands I have purchased I have never see one that was not painted.
For a while they were selling the combinations service entrance devices in white instead of the standard gray.
 
curt swartz said:
Sounds like someone must have put a ABB, Siemens or Eaton loadcenter in a SquareD box.

Per SquareD specs:
Homeline finish consists of gray baked enamel electrodeposited over cleaned, phosphatized steel.

I have been buying HOM loadcenters since they were first launched. Of the thousands I have purchased I have never see one that was not painted.
For a while they were selling the combinations service entrance devices in white instead of the standard gray.
Click to expand...
I didn't buy the panel. I installed it for a small Church and they bought it. I opened the box and it was not taped like it was returned. It was factory packaged. I had to add a ground bar and know it was not painted. Maybe it was a mistake from the factory. I haven't installed very many SqD products and never paid attention to the others.
 
You must log in or register to reply here.
Top