Not enough neutrals in panel.
- Thread starter jpd24
- Start date
- Status
hbiss
EC, New York NEC: 2017
- Location
- Little Falls, New York NEC: 2017
- Occupation
- EC
Re: Not enough neutrals in panel.
No reason you can't add another ground bar. Check the listing also. Some panels may allow doubling up of the grounds.
-Hal
No reason you can't add another ground bar. Check the listing also. Some panels may allow doubling up of the grounds.
-Hal
A
a.wayne3@verizon.net
Guest
Re: Not enough neutrals in panel.
Some allow 2 some even 3 ground wires to terminate under 1 lug but all I have seen only allow wires of the same gauge to terminate under 1 lug.
Some allow 2 some even 3 ground wires to terminate under 1 lug but all I have seen only allow wires of the same gauge to terminate under 1 lug.
A
a.wayne3@verizon.net
Guest
Re: Not enough neutrals in panel.
Some allow 2 some even 3 ground wires to terminate under 1 lug but all I have seen only allow wires of the same gauge to terminate under 1 lug.
Some allow 2 some even 3 ground wires to terminate under 1 lug but all I have seen only allow wires of the same gauge to terminate under 1 lug.
A
a.wayne3@verizon.net
Guest
Re: Not enough neutrals in panel.
Atm machines are out there to make a profit so in escense they are there to sell a product (access to money for a fee)a coke a bag of chips a candy bar,$20.00.ATM`S are everwhere so why shouldn`t they be gfci protectedYou find them outdoors at state and county fairs,at your bank.Even in bathrooms.
Atm machines are out there to make a profit so in escense they are there to sell a product (access to money for a fee)a coke a bag of chips a candy bar,$20.00.ATM`S are everwhere so why shouldn`t they be gfci protectedYou find them outdoors at state and county fairs,at your bank.Even in bathrooms.
A
a.wayne3@verizon.net
Guest
Re: Not enough neutrals in panel.
No roger it was supposed to post in What is a vending machine.Still looking to avoid cad welding our ground wires any luck?
No roger it was supposed to post in What is a vending machine.Still looking to avoid cad welding our ground wires any luck?
hurk27
Senior Member
- Location
- Portage, Indiana NEC: 2008
Re: Not enough neutrals in panel.
The neutral bar has to be identified for the purpose of landing both grounding and grounded conductors on it when used with NM. As it says in 408.20.
There were a few manufactures that didn't identify there bars in the panel label so we had to buy the add on grounding bar when NM was used.
These panels will usually only have enough terminals to just land the neutrals if every space in the panel was used with a single pole breaker. T&B was one of them.
The neutral bar has to be identified for the purpose of landing both grounding and grounded conductors on it when used with NM. As it says in 408.20.
There were a few manufactures that didn't identify there bars in the panel label so we had to buy the add on grounding bar when NM was used.
These panels will usually only have enough terminals to just land the neutrals if every space in the panel was used with a single pole breaker. T&B was one of them.
- Status