Dan Kissel
Member
- Location
- st louis, mo
Normally I use Schneider Electric I-Line panelboards but there lead time is too far out. I am considering their NF panel boards because my circuits are 3p- 3W 30 amps or less but I need about 24 of them and we always run IMC. Is the NF panel board (20W x 6.5 D) still a good consideration? Would you run 5 or 6 circuits in one 2 " conduit just to get the wires out of the panel, then drops to individual machines? BTW I'm pulling #8 wire.
